Topics Engaged In
-
- Cummins Marine Forum Topics
-
-
Engine wonāt crank after losing fuel shut off solenoid
This topic has 1 reply, has 2 voices, and was last updated by 2 years ago
October 24, 2021 at 6:21 am After running a few hours yesterday we stopped at our destination and started to smell something burning. Opened the engine hatch and found smoke coming from the solenoid. Went to shut off the key but motor Stayed running so I lifted the lever on the solenoid to shut it down. Now the motor wonāt do anything at all, wonāt crank just completely dead. The motor is a 6bta 5.9 315 hp. Thanks for the help and figured I would ask first before I start r…
1 ReplyOctober 25, 2021 at 12:17 pm Really not something that can be “solved” over a forum. You need to do investigate all with a multimeter starting at the engine battery and working your way back to the engine and ignition/start circuit. Keep us posted…
-
Throttle creeping back
This topic has 5 replies, has 3 voices, and was last updated by 5 years ago
October 30, 2018 at 6:15 pm I have Cummins 6bta 315hp. The starboard throttle creeps back when underway, and has a little spring back just above idle speed. Is there an adjustment that I can do to stiffen up the throttle? Thank you
5 RepliesNovember 3, 2018 at 6:46 pm A better pic attached of what you have…………………….Basically Cummins came up with an extended arm and “balance spring” to operate the throttle on the ND injection pumps.. It “kinda works” but in many cases you have to play the the tension of the balance spring or add a small 2nd spring to take out some of the “balance…..This is something you just need to learn and mo…
-
Oil pan heaters
This topic has 4 replies, has 3 voices, and was last updated by 6 years ago
November 9, 2017 at 7:15 pm I need to re apply oil pan heater on my motor. What type of silicon or adhesive do you suggest. Thank you
4 RepliesNovember 10, 2017 at 7:26 pm Curious……………..What happened? Toy
-
Running hot
This topic has 6 replies, has 4 voices, and was last updated by 6 years ago
August 5, 2017 at 1:39 pm I have twin 6bta 315 hp my port motor is fine till I put a real load on it 2000 rpm and heats up to 200 degrees. When I slow down it drops fairly quickly. I have a new seaboard water pump, went through raw water side cleaned heat exchanger. What else should I look for. Thanks
6 RepliesAugust 7, 2017 at 4:39 am The pump was replaced this spring I will check into the thermostat
-
Engine wonāt crank after losing fuel shut off solenoid