• Creator
    Topic
  • #162784

    Tim Vandersall
    Participant
    Vessel Name: Wilma May
    Engines: Single Cummins QSB 5.9 380HO
    Location: Scottsboro, AL
    Country: USA

    Hello guys, I will be draining and replacing coolant on my 2005 Mainship for my first time.  In reviewing your technical info, you show a drain plug at the red arrow, but mine does not have a plug there.  I do see a plug at the other end of this tube, as shown in my photos where my finger is pointing (the next is the close up one is from underneath the tube).  Wondering if you can confirm if this would be the drain plug, and if you have any tips on refilling.  Any help is greatly appreciated.  Thank you!!

Viewing 3 replies - 1 through 3 (of 3 total)
  • Author
    Replies
  • #163072

    Tony Athens
    Moderator
    Vessel Name: Local Banks
    Engines: QSB 6.7 550 HP
    Location: Oxnard, CA
    Country: USA

    The plug under here will drain the entire system

    #162996

    Tim Vandersall
    Participant
    Vessel Name: Wilma May
    Engines: Single Cummins QSB 5.9 380HO
    Location: Scottsboro, AL
    Country: USA

    Still cannot find-see new photo

    I do not see any other drains in the location that pic 1 from Seaboard shows there should be one.  I circled the zinc that I’ve changed a few times on this new photo, and put another circle where the only plug is that I can find in this area. Still confused.  Sure seems like the plug is the only possible low-lying drain potential.

    #162964

    Fireisland1
    Participant
    Vessel Name: Riverwind
    Engines: cummins QSB 380
    Location: long island n.y.
    Country: usa

    Pic 2 is a zinc. Not a drain. That is raw water side of HE. Look below and aft for the aintfreeze drain

Viewing 3 replies - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.