Favorite Forum Topics

Viewing topic 1 (of 1 total)
    • Cummins Marine Forum Topics
    • QSC front mounts

      This topic has 4 replies, has 3 voices, and was last updated byTy Anderson 2 years ago

      May 22, 2021 at 7:58 pm Iā€™m installing a running takeout QSC 540 into my boat and found the dimensions I used to set up the engine beds to be off it seems. Dropped the motor into the boat last night and had to set it on blocks as the front beds seemed way too low. There seem to be spacers between the engine bracket, this a factory part as I plan to take them out. Two, I see an arrow pointing up on the mount but it would be beneficial for me to flip these upside down. I…

      Started by: Ty Anderson in: Cummins Marine Engines

      4 Replies
      May 23, 2021 at 5:03 pm Thank you everyone for confirming this. Engine was dropped into the boat two nights ago and today I spent some time gathering up the tools and supplies to assemble the gantry in the wheelhouse to lift and shift the engine around. After some measuring today Iā€™m 3/8 high on the gear end and have to shift the rear a good inch to port so looks like I may have to notch the stringer to clearance the fuel cooler and fittings on it.

      Last Post by: Ty Anderson posted: 2 years ago

  •  

Viewing topic 1 (of 1 total)