Forum Topics Started
-
- Cummins Marine Forum Topics
-
-
6CTA aftercooler/hx helpful tool
This topic has 1 reply, has 1 voices, and was last updated by 2 years ago
December 21, 2021 at 2:35 pm Crested a tool out of necessity to remove stubborn 6CTA aftercooler cores and to put the spring back in heat exchanger endcaps. Buy a 4ā pvc coupler. Itāll be a tad too big for the aftercooler housing. Use a circular saw or mitre saw or table saw and make one pass through it. Now when you squeeze it together itās the perfect diameter if you need to use force with a block of wood to drive the aftercooler core through until the ends clear the …
1 ReplyDecember 21, 2021 at 2:39 pm Hmm. Picture I attached didnāt upload. Let me try again.
-
Leaking SMX pump
This topic has 17 replies, has 6 voices, and was last updated by 3 years ago
August 31, 2020 at 6:09 am I bought two new SMX pumps in late 2014 and installed them on my 450 Diamonds. The hard to get to port pump has started leaking. Pictures of good starboard pump and suspect port pump. Notice port pump has green all around water weep holes to drain water when water seal fails. Starboard pump is pristine there. I plugged bottom most weep hole with dry paper towel and ran engine for five minutes. When I pulled out the towel the inside of it wa…
17 RepliesOctober 29, 2020 at 12:03 pm Humpty Dumpty is back together. First picture is the cleaned out housing ready for the new seal. Second picture is the new main seal installed. That went in easy pushing with gloved fingertips. Final picture is with the shaft seal and cap locked in place with the retaining clip. To push the clip in place I used a piece of 1ā pvc pipe. It was the right inside diameter to push the clip down until it snapped into its shaft groove.
-
6CTA aftercooler/hx helpful tool