Topics Engaged In

Viewing 2 topics - 1 through 2 (of 2 total)
    • Cummins Marine Forum Topics
    • Help replacing shaft seal

      This topic has 7 replies, has 4 voices, and was last updated byRob Schepis 6 years ago

      November 22, 2017 at 11:00 pm New to the forum. I’m out of Biloxi, MS and I’m running a 25ft Whitewater center console straight shaft inboard. Not too many guys run this kind of setup here but as I have found it eats up the nasty weather we get so its a win for me. I’ve been an outboard guy before this and this is my first inboard boat so I’ve learned a lot over the past two years of ownership. Now on to the topic, I am currently going through a repo…

      Started by: Matt Pickich in: All Other Marine Diesels

      7 Replies
      November 29, 2017 at 11:51 am Yes sir. See attached..

      Last Post by: Rob Schepis posted: 6 years ago

    • 6CTA8.3m Overheat issue 1 2

      This topic has 29 replies, has 4 voices, and was last updated byTony Athens 6 years ago

      November 6, 2017 at 10:23 am I am knocking my head against the wall here. Any suggestions welcome. Heres the timeline of this issue. 1. 4mos ago an impeller failed underway. Overheat to 210, I replaced the impeller at sea and all was fine 2. 2 mos ago I had the serpentine belt fail, Overheat to 210, replaced the belt at sea, all fine 3. 1 month ago random overheat at sea, towed in a. I had some parts, all new so I replaced the fresh water pump, sea water pump and impel…

      Started by: Bob Bonser in: Cummins Marine Engines

      29 Replies
      November 26, 2017 at 1:50 pm Bob, Any good with a camera? Let’s drain the coolant down, get all apart and get all clean. Buy a composit gasket from Brad and 4 new studs and nuts. Display all so I can SEE EVERYTHING and I’ll walk you thru it.. Something is not right and I do not belieive the right gasket and assembly will not put this behind you. Tony

      Last Post by: Tony Athens posted: 6 years ago

  •  

Viewing 2 topics - 1 through 2 (of 2 total)