[Mark Glaubke]

Thank you Tony. When i installed these engines I used all your advice and tips!!! The seaboard way!

[Mark Glaubke]

Rob, still playing with wheels as of now wide open is 2850 4 blade 18×25’s. Before the 4 blade18 x25’s i tried 18×23 3 blades and was against the governor. I have not photo tached.

[Mark Glaubke]

Help anyone?

[Mark Glaubke]

Rob my idle is 650. the pressure goes up to about 350lbs not in gear

[Mark Glaubke]

Thank you Rob. Question how much antifreeze do I have to drain?

[Mark Glaubke]

zf 220a 1.5 to 1 not in gear its at like 350

[Mark Glaubke]

Help anyone boat just splashed trying to get right

[Mark Glaubke]

Rob, I’m kind of new to all this port motor stays around 180. Should i change out the thermostat on the starboard side that drops to 110 ?

[Mark Glaubke]

help anyone please

[Mark Glaubke]

Tony could you please review the attached pictures? Your thoughts.

[Mark Glaubke]

Tony here is another picture not sure if you got previous pic this is starboard panel

[Mark Glaubke]

Tony here is picture of the starboard side.Purple wire attached to ignition stud on circuit board.

[Mark Glaubke]

Rob so i need to cut the yellow/red wire to tie into neutral safety switch?

[Mark Glaubke]

Tony I am installing the engines now. The engines where supplied with FF 5285 fleet guard filters! I am remote mounting the on engine fuel filter housings keeping all plumbing the same using your double double filtration system. The nipple was correct on starboard engine wrong on port engine same housings

[Mark Glaubke]

Tony I have the Bosch injection pump.

[Mark Glaubke]

Corey,

Keeping my fuel cooler . So just run the return line from the fuel cooler to tank correct?

[Mark Glaubke]

Corey,

I got it thanks

[Mark Glaubke]

Corey,

I searched what you suggested under Tony’s tips. Nothing came up in search results. Help.

Thanks,
Mark

[Author]

Replies