Cummins engine Panels circuit board - Cummins Marine Forum

This topic has 5 replies, 2 voices, and was last updated 3 years ago by Tony Athens.

Creator

Topic
July 23, 2020 at 4:19 am #101231

Mark Glaubke
Participant
Engines: Cummins 6bta
Location: Norfolk
Country: United States

Yesterday I was installing my panels and noticed on the port panel circuit board no wire was attached to the ignition stud.The starboard panel has a purple wire attached to that stud.Could the port panel be wired differently? Should there be a wire attached to the ignition stud and from where?
Creator

Topic

Viewing 5 replies - 1 through 5 (of 5 total)

Author

Replies
August 11, 2020 at 4:39 am #102180

Tony Athens
Moderator
Vessel Name: Local Banks
Engines: QSB 6.7 550 HP
Location: Oxnard, CA
Country: USA

PCB boards

Mark,

Send both picture to me direct as high res .jpgs I fail to see what ever you want me to see.

[email protected]

August 11, 2020 at 4:16 am #102179

Mark Glaubke
Participant
Engines: Cummins 6bta
Location: Norfolk
Country: United States

Tony could you please review the attached pictures? Your thoughts.

July 28, 2020 at 4:02 am #101469

Mark Glaubke
Participant
Engines: Cummins 6bta
Location: Norfolk
Country: United States

Tony here is another picture not sure if you got previous pic this is starboard panel

July 27, 2020 at 3:41 am #101408

Mark Glaubke
Participant
Engines: Cummins 6bta
Location: Norfolk
Country: United States

Tony here is picture of the starboard side.Purple wire attached to ignition stud on circuit board.

July 25, 2020 at 12:37 pm #101336

Tony Athens
Moderator
Vessel Name: Local Banks
Engines: QSB 6.7 550 HP
Location: Oxnard, CA
Country: USA

Post a pic of the other side ( same view) so I can see the difference you are referring to
Author

Replies

Viewing 5 replies - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.