Forum Topics Started

Viewing topic 1 (of 1 total)
    • Cummins Marine Forum Topics
    • CCM Multisensor Fault Code

      This topic has 7 replies, has 6 voices, and was last updated byPhil Lack 7 months ago

      March 18, 2019 at 1:05 am Hi, Recently have had cases of alarm, fault code of “CCM Multisensor Lever 1” when engaging Starboard drive. Engine still runs. No drive. Can cure it by stopping / starting the Stbd engine.Then engages fine. Happens sporadically, but getting more frequent. Cummins QSC with ZF 305 A Transmission. Any others with this problem, or who have cured it? Much appreciated. Thanks.

      Started by: Keith Donaldson in: Instrumentation & Electronics

      7 Replies
      September 10, 2023 at 1:36 am Hello all, after I experienced this same problem I searched the SBM forums and found this thread. My boat has twin QSB 5.9 440 HP Cummins and is fitted with a Smartcraft displayĀ  and a remote Yacht Controller. I have upper and lower helm stations. 3 months ago I was leaving my slip and had the Yacht Controller active and connected. I toggled both engine into reverse but only the STB engine went into gear. Port engine just idled. Only the STB eng…

      Last Post by: Phil Lack posted: 7 months ago

  •  

Viewing topic 1 (of 1 total)