Forum Topics Started

Viewing topic 1 (of 1 total)
    • Cummins Marine Forum Topics
    • EGT Temps on VV7

      This topic has 6 replies, has 3 voices, and was last updated byDave Shapiro 3 years ago

      October 6, 2020 at 4:15 am I have a 2010 SeaRay Sundancer 500 w QSC 550s and Zeus Pods. The PO had the dieselview replaced with a VesselView7 Under the “ADVANCED” tab I get Load Throttle Boost Trans Oil Pressure But no where do I see Exhaust Gas Temps. I know there is a sensor for it because I had one go bad at the beginning of the season and it threw off an alarm code. Is there any place I can monitor those values? Any way to program it into the VesselView7?…

      Started by: Dave Shapiro in: Cummins Marine Engines

      6 Replies
      October 6, 2020 at 6:21 am Thanks Dave, Thinking about it, I think you are correct for my situation as well. That EGT sensor is indeed in the water flow. Not sure I am going to install another sensor..

      Last Post by: Dave Shapiro posted: 3 years ago

  •  

Viewing topic 1 (of 1 total)