Forum Topics Started
-
- Cummins Marine Forum Topics
-
-
VesselView alarm on QSM11
This topic has 7 replies, has 3 voices, and was last updated by 5 years ago
February 14, 2018 at 6:58 am I am getting an alarm on my smart craft vessel view gauge on one of my two QSM 11ās. It reads: 0x80040702 Class = MTDataEngine Method = MTInitiaize Pic attached I have searched manuals, and Internet, and canāt find out what this means? Any help would be greatly appreciated. Thank you
7 RepliesSeptember 4, 2018 at 5:27 am I wish I could help. That code cleared itself. It never affected performance or shut me down. There was no changes made before or after the code disappeared. Sorry I canāt be more help, was just glad the problem disappeared.
-
ZF 325 -1A low gear oil pressure
This topic has 2 replies, has 2 voices, and was last updated by 6 years ago
January 19, 2018 at 2:28 pm Hello and thank you for any help with my problem. First post on the forum. I have a new to me 46 foot Bertram sport fish that was completely redone in 2011/12. Re-powered with QSM11 remanās with ZF 325ā1 A transmissions. These are electric shift throttles and trans run by a Gleninning system with trolling valves. Gear pressure is low on starboard trans running about 100 psi, consistent in neutral or in gear. Have not noticed a performance …
2 RepliesJanuary 26, 2018 at 3:39 am Well Iām a little embarrassed, at least I donāt have a gear problem. I discovered that this boat has two different transmission controllers. The starboard gear has a EB 30 controller, port has the EB 31 controller. The low pressure on the starboard gear led me to believe that I had a transmission problem. The EB 30 controller does not show full operating pressure until put in gear and given some rpm. The EB 31 controller shows full operatin…
-
VesselView alarm on QSM11