Forum Topics Started

Viewing 2 topics - 1 through 2 (of 2 total)
    • Cummins Marine Forum Topics
    • Delphi Injection Pump Timing 6bt

      This topic has 2 replies, has 2 voices, and was last updated byjohn 4 years ago

      August 16, 2019 at 12:35 pm Where can I find (Buy) the procedure/manual to time the delphi injection pump to a disturbed engine? The engine was moved after the pump was removed ,doph . Mike

      Started by: Michael Starr in: Cummins Marine Engines

      2 Replies
      August 19, 2019 at 8:03 am The weird part is it lost its prime overnight. Never seen that before. Hopefully it’s done now.

      Last Post by: john posted: 4 years ago

    • water take off from SMX 1730 pump

      This topic has 12 replies, has 4 voices, and was last updated byMichael Starr 5 years ago

      June 5, 2018 at 12:27 pm Engine is 6BT 210. I recently replaced the trans cooler with one that has the two zincs. The cooler that came with the engine only had one small outlet that was used to supply the dripless shaft seal with cooling water. The new unit has openings for the two zincs. I wanted to keep the two zincs in the tube so I was looking for another location to get water to cool the shaft bearing. I found two plugs on either side of the SMX impeller cover. I …

      Started by: Michael Starr in: Cummins Marine Engines

      12 Replies
      June 12, 2018 at 10:21 am I appreciate all the advice. I contacted Tony and he sent this article FYI. Best Locations to get Water Flow for Shaft Packings Mike

      Last Post by: Michael Starr posted: 5 years ago

  •  

Viewing 2 topics - 1 through 2 (of 2 total)