Forum Replies Created

Viewing 5 replies - 1 through 5 (of 5 total)
  • Author
    Replies
  • #29220

    Zach Babcock
    Participant
    Vessel Name: Knee Deep
    Engines: QSC-600
    Location: Bayport MN

    I will get a full set of data when the boat splashes in April and repost then.

    Rob,

    On the attachment I don’t see an axis to plot fuel consumption. What am I missing?

    #28887

    Zach Babcock
    Participant
    Vessel Name: Knee Deep
    Engines: QSC-600
    Location: Bayport MN

    Thanks

    What data will be required to better determine what needs to be done with the props?

    Any suggestions for a prop shop and or location to purchase new props from?

    #28873

    Zach Babcock
    Participant
    Vessel Name: Knee Deep
    Engines: QSC-600
    Location: Bayport MN

    Fuel filters are visually clean – under a 80 hours since last replacement but will be replaced this spring

    Running gear is good – no growth or build up.

    I didn’t get boost readings.

    We will be back in the water mid/late April. Is more data required to properly understand the issue?

    Are there any shops that you can purchase new props from and send back the ones on the boat? Trying to avoid launching the boat then pulling it back out and letting it sit for a week plus once the season starts.

    #28868

    Zach Babcock
    Participant
    Vessel Name: Knee Deep
    Engines: QSC-600
    Location: Bayport MN

    Normal cruise is 2450-2550

    We are on plane at 2200

    #28862

    Zach Babcock
    Participant
    Vessel Name: Knee Deep
    Engines: QSC-600
    Location: Bayport MN

    Here are the MRI scans of the Props post repair for low RPM on port side

Viewing 5 replies - 1 through 5 (of 5 total)