• Creator
    Topic
  • #161526

    Blake H
    Participant
    Engines: 6BTA
    Location: Long Island, NY

    Replaced the lines. Trying to figure out best method to refilling and bleeding the air out. <br /><br />

    Also I’ve seen the seaboard team use reservoirs for the hydraulic fluid. Where can I source the reservoir?

     

     

     

Viewing 3 replies - 1 through 3 (of 3 total)
  • Author
    Replies
  • #161611

    Richard Dodson
    Participant
    Vessel Name: SWAY
    Engines: 6CTA 8.3 480
    Location: Kent Narrows, MD
    Country: USA

    Get the manual from the manufacturer. They have very specific steps on bleeding the system. 

    #161539

    Blake H
    Participant
    Engines: 6BTA
    Location: Long Island, NY

    Thanks Tony. <br /><br />

    Do you know where I can source a reservoir so I can have an excess of steering fluid as you recommend?

     

    Also, do you know the model number for my helm pump? The sticker fell off and I’d like to know just in case I need to reference it in the future.

     

    Thank you 

     

    #161533

    Tony Athens
    Moderator
    Vessel Name: Local Banks
    Engines: QSB 6.7 550 HP
    Location: Oxnard, CA
    Country: USA

    Look at the attached Picture   Bleeding any system like this  system is done at the ram.. 

    A basic  instruction page in attached applicable your system.

    Look for u-tube videos on the subject– You do not have a 3-line pressured  tank system    

Viewing 3 replies - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.