Forum Topics Started

Viewing 3 topics - 1 through 3 (of 3 total)
    • Cummins Marine Forum Topics
    • CCV Kit Filter Cleaning

      This topic has 2 replies, has 2 voices, and was last updated byMarvin Lewis 4 years ago

      August 26, 2019 at 10:57 am So I am a little confused. You sell a cleaning and oiling kit for the S&B Filters that go with the CCV kits. The instructions for the cleaning kit say not to use anything but the cleaning solution and then re-oil the filters using the supplied filter oil. But, under the cleaning and care tab on the filter ordering page you indicate that the filters can be cleaned simply by using Dawn or some other dish soap and oiling is not necessary as t…

      Started by: Marvin Lewis in: General Discussion

      2 Replies
      August 27, 2019 at 8:36 am Thanks Tony. Appreciate all you guys do to help us out in the field.

      Last Post by: Marvin Lewis posted: 4 years ago

    • 6Bta Oil in turbo

      This topic has 4 replies, has 2 voices, and was last updated byMarvin Lewis 4 years ago

      August 11, 2019 at 3:14 pm Good evening. I have a fairly new set of 6Bta 330’s that have the seaboard CCV kit on them. I removed the air filter on the starboard engine today and there was a fair amount of oil in the turbo. There is also a soot/oil stain on the exterior of the exhaust side of the turbo/. See pics. Is this common with the CCV kits????? If not, should I be worried and what could be causing this? Engines run fine but after idling a while (such as…

      Started by: Marvin Lewis in: Cummins Marine Engines

      4 Replies
      August 12, 2019 at 9:42 am Rob My apologies, these are rebuilds. I’ll take some good pics this weekend and post them. I’ll also change the oil as suggested. Thanks Marvin

      Last Post by: Marvin Lewis posted: 4 years ago

    • Cummins 6BTA Turbo oil inlet pipe

      This topic has 1 reply, has 2 voices, and was last updated byRob Schepis 6 years ago

      April 9, 2018 at 1:32 pm Hello, I am replacing my turbo on a Cummins Marine 6BTA that has a Holset HX40 Turbo on it. The oil injector/inlet pipe that runs from the front of the engine to the oil port on the turbo is bad and I am having a heard time finding one. Pipe is about 2.5 to 3 feet ling with flared fittings on the ends and a armor reinforced exterior that runs along the tome of the engine. Any help would be appreciated. I am not 100% sure what the hose/pipe i…

      Started by: Marvin Lewis in: Cummins Marine Engines

      1 Reply
      April 9, 2018 at 3:39 pm Post the engine serial number.

      Last Post by: Rob Schepis posted: 6 years ago

  •  

Viewing 3 topics - 1 through 3 (of 3 total)