Forum Topics Started
-
- Cummins Marine Forum Topics
-
-
QSC8.3 incorrect oil pressure
This topic has 1 reply, has 2 voices, and was last updated by 3 years ago
June 12, 2020 at 9:06 pm My 2007 qsc8.3 490 w/smart craft oil pressure reading acts like a switch. It either reads zero when warm at idle or 69 psi above 1100 rpm. Sender is correct. I traced 3 wires to connector. ground is good. Voltage supply is good and reference varies as supposed to . So oil sensor and wiring doing what their supposed to up to the block. I really can’t arbitrarily change computer components to fix. Any known way to test? Manual oil gauge …
1 ReplyJune 13, 2020 at 6:39 am Buy a new OP sender
-
2007 QSC 8.3 smart craft oil pressure
This topic has 4 replies, has 3 voices, and was last updated by 4 years ago
June 20, 2017 at 10:34 am Any help would be appreciated. 2007 qsc 8.3 . 1700 hrs. All was fine until on way home from fishing trip, low oil reassure alarm and low oil code went on and smart craft display said 0 pressure. I took off sender and installed pressure gauge. Pressure was 59 and warmed up at Idle was still in 30s. I purchased a sender locally. Now alarm off started cold but as engine warms alarm and low pressure code come back. Smartcraft reads 69 at anythin…
4 RepliesAugust 16, 2019 at 8:45 am Iām having the same issue with my 2007 QSC 8.3. Low oil pressure alert code 415 indicating 0.0 PSI. Towed into Shearwater, BC, pressure manually checked good (70 PSI within 5 seconds of engine start). Having sender unit that Coreyās post indicates flown in today from Vancouver but based on this post and another, Iām not sure this will fix problems. Mechanic here does not think this is a wiring issue, nor the low coolant sensor leaking issue, but…
-
qsc 8.3 w/ ZF intermittent reverse
This topic has 9 replies, has 4 voices, and was last updated by 5 years ago
February 22, 2017 at 6:22 pm I would appreciate any help with this problem. IĀ have smart craft electronic controls.Ā reverse does not initially always engage on port engine when control is put in reverse . If I shift from reverse back to Neutral a couple of times it works. Tried switching solenoids, no difference. If I turn manual override screw under solenoid cover always works.Ā Any tips would be helpful.
9 RepliesSeptember 9, 2018 at 7:02 pm Thanks Tony. I do plan to take it apart to get to a final resolution. Giving it a whack was the short term fix when offshore or backing down a fairway to dock. Iāll get a better picture of the configuration on the transmission.
-
QSC8.3 incorrect oil pressure