Forum Topics Started

Viewing topic 1 (of 1 total)
    • Cummins Marine Forum Topics
    • QSB VesselView 4 with NMEA

      This topic has 2 replies, has 3 voices, and was last updated byWayne Spalding 4 years ago

      November 12, 2018 at 2:08 pm Not sure if this should be under Cummins or Electonics but assume Cummins at this point. Just re-powered my Bertram31 with Cummins QSB 5.9 380s with 2 VesselView 4s at the same helm. I have been operating with segmented Engines set both to Master and had a dedicated VV4 as the Gauge for the Port and Starboard (however the Port VV reported the its engine as Starboard). THANKS to a discussion with Corey –i switched the Jumper on the MUS …

      Started by: Robert Shapiro in: Cummins Marine Engines

      2 Replies
      July 20, 2019 at 7:06 am Did the link between the engine harness junction boxes fix the problem? I have an identical issue with my set up, although my SIM are version 1

      Last Post by: Wayne Spalding posted: 4 years ago

  •  

Viewing topic 1 (of 1 total)