Forum Topics Started
-
- Cummins Marine Forum Topics
-
-
SMX Digital 6CTA external alarm
This topic has 6 replies, has 3 voices, and was last updated by 6 years ago
March 14, 2018 at 4:32 pm I want to hook up an external alarm to the SMX Digital View display for my Cummins 6CTA 8.3. From the webpage it looks like the alarm lead closes to ground when there is an alarm. Can I hook that lead (pin3) up to an external buzzer ground and run a fused positive lead to the positive end of the buzzer? Thanks
6 RepliesMarch 17, 2018 at 9:31 am I see, yes you are correct that the panel set points for the ED-1/ED-X display on a 480CE cannot be changed because that set-point number is determined by the engine ECM controller… not the display. Think of your display as a “monitor” and nothing else. The displays we use (SMX DigitalView) to indicate instrumentation on mechanical engines uses software that Seaboard developed in-house and therefore we have much more flexibilit…
-
6CTA Tach Signal
This topic has 1 reply, has 2 voices, and was last updated by 6 years ago
January 18, 2018 at 3:59 pm I’m looking at adding an additional tachometer to my 6CTA. Can i just tap into the signal wire off the magnetic pickup or is it more complicated? Thanks.
1 ReplyJanuary 19, 2018 at 5:44 am Normally the factory pickup can drive two tachs by just “tapping is as you said. There are wiring diagrams on this web site Tony
-
Engine Compartment Ventilation 6CTA 8.3 430
This topic has 3 replies, has 3 voices, and was last updated by 6 years ago
May 30, 2017 at 5:25 pm Looking to relocate the ventilation for my engine to inside the cabin. How many cubic inches of ventilation space are needed for a Cummins 6CTA 8.3 430 Diamond?
3 RepliesMay 31, 2017 at 3:37 pm Thanks Tony and Rob, That’s all the information I need.
-
SMX Digital 6CTA external alarm