- This topic has 1 reply, 2 voices, and was last updated 3 months ago by
.
-
Topic
-
Hello I’m pretty stuck and looking for advice. I have a gianetti 58 with twin cummins qsm 11 coupled to zf325 a1 gearbox. The port engine is giving me some trouble. It was working normally, until one of the hydraulic lines to the oil cooler (rusted at the coupling) and leaked the fluid out. At which point I had no forward or reverse. I replaced the hose, filter and refilled and now I have reverse but no forward. When in neutral the shaft slowly turns in the forward direction. It will go in and out of reverse no problem. But I can’t get forward to engage. I’ve taken off the control box checked all the O rings and it looked OK but still no luck getting forward gear. Ive disconnected the cable linkage and move the lever with my hand and still same result. Attached should be a video, sorry for the poor quality.
Any suggestions?
You must be logged in to reply to this topic.