- This topic has 2 replies, 2 voices, and was last updated 5 years ago by .
-
Topic
-
Just serviced oil and heading back to the slip. Motors are at cruise power about 2200 rpm of 2880. I hit a wave while reaching for the trim switch and my fat finger bumped the stop switch on the port engine shutting it down.
Stopped the boat, tried to restart and couldnāt get the mistaken shut down motor to turn over. Finally realize it was still in gear put it in nuetral and started right up. The boat ran fine home but now Iām obsessing that I may have damaged that turbos bearings. Does the prop āwindmillā the motor as it spins down? What do you guys think and how would I know if I did cause damaged?
Thanks! Joe
Viewing 2 replies - 1 through 2 (of 2 total)
Viewing 2 replies - 1 through 2 (of 2 total)
You must be logged in to reply to this topic.