Topics Engaged In
-
- Cummins Marine Forum Topics
-
-
Mercury smartcraft replacement
This topic has 16 replies, has 6 voices, and was last updated by
3 years ago May 14, 2019 at 7:28 pm I am interested in replacing my Mercury marine smart craft computer. I have a 2009 Meridian with twin 5.9 cummins diesels. I have been told that because I also have a DTS throttle control system that I cannot replace the smart craft with an after market system. Is that true? What are my options? Thanks, Jon Arnold
Started by:
in: Instrumentation & Electronics
16 RepliesOctober 14, 2020 at 11:30 am ynoty3k wrote: Those are just the displays, correct? What about swapping to straight j1939 controls and removing the full smartcraft system? The system referenced above will replace everything SmartCraft on your boat physically including the harnessing and start/stop key(s), etc.Last Post by:
posted: 3 years ago
-
Dieselview only showing Port data – both smartcra
This topic has 3 replies, has 2 voices, and was last updated by
5 years ago February 25, 2019 at 12:29 pm Recently purchased a 2007 40 Sea Ray with Twin QSB 5.9. The Dieselview screen is actually in good shape however it only shows data from the port engine (engine & fuel). All dash gauges work for both engines. I tried cleaning the terminals for the starboard engine where it plugs into the dieselview but no change. I’ve been reading through the forums and from what I gather if this was a problem with the connection at the engine my dash …
Started by:
in: Instrumentation & Electronics
3 RepliesMarch 11, 2019 at 3:12 pm I do not think it’s a problem with the display unit but the only way to tell is to have another unit to swap with. You may try swapping the SIM modules on the engines to see if you can get the issue to switch sides? Also check that the MUS ID jumpers are set correctly… there’s an article on our website on how to do this. Welcome to the SmartCraft world…Last Post by:
posted: 5 years ago
-
Mercury smartcraft replacement
