Forum Topics Started
Viewing topic 1 (of 1 total)
-
- Cummins Marine Forum Topics
-
-
Cutlass bearing set screw layout?
This topic has 1 reply, has 2 voices, and was last updated by 4 years ago
July 10, 2019 at 8:16 pm Iām in the process of rebuilding the stern tube in my 25ā Downeast boat and need to drill and tap the tube for set screws to fix the cutlass bearing. Is there a recommended layout for the screws? Iāll be using cone point set screws and can spot drill the cutlass. The cutlass is a light press fit into fiberglass. The page on installing shafts, logs, and struts is really helpfull https://www.sbmar.com/articles/installing-shafts-logs-struts-rudder…
1 ReplyJuly 12, 2019 at 7:45 pm This is how we do it and have been for 25 Yrs +……….My own protocol based on “logic” as to what needs to be accomplished… 1) I never use a press fit on the stern bearing–NEVER means just that.. I always want the bearing to slide in and out by hand…………Sand, grind, machine what is needs to get a “SLIDE FIT”.. .010″-.030″ clearance is a good number, but that…
-
Cutlass bearing set screw layout?
Viewing topic 1 (of 1 total)