Forum Replies Created
-
AuthorReplies
-
January 18, 2022 at 9:06 am #125318
Thanks much for the response Rob. A little more than 1/4″ of meat. Thinking about grinding down to smooth surface.
April 12, 2019 at 7:33 am #66831Thanks Tony & John, great info. I am in almost the exact same situation. I just purchased envirovent and have a couple follow-on questions (my setup is 2006 6bta59 without airssep, open system – breather tube bottom of T just puts blowby into engine room).
(1) Can you describe exactly where the old factory breather tube connects at the back of the engine near the aftercooler? If I understand correctly I need to disconnect here and cap it. I can’s seem to find it – everything looks so buried. Should I be able to see it without removing anything? Also, does the kit include a cap for this?
(2) What engine parts should I expect to need to remove in order to pull out old factory breather assembly? It seems removal is a big job but envirovent install much easier?
Thanks much in advance for your feedback.
-
AuthorReplies