Favorite Forum Topics
-
- Cummins Marine Forum Topics
-
-
Onan genset and 45 error
This topic has 2 replies, has 2 voices, and was last updated by
3 years ago November 12, 2020 at 1:25 pm Hello guys. Have replaced last week worn out fuel camshaft on one Onan with Kubota V2403 engine,and now,as usually goes,it starts,runs few seconds,and shuts down with that error. I know that usually means winding damaged or controller unit,but in this case genset worked fine,before this “operation”. It starts sometimes also difficult,like it has air in system,but i bleed it directly on injectors above. I will try to check winding re…
Started by:
in: All Other Marine Diesels
2 RepliesNovember 13, 2020 at 12:08 am Hello Tony. Yes,understand,but asking can’t do no harm. I will try to sort this genset today,fingers crossed,and for sure will come back with results. Thank you for reply.Last Post by:
posted: 3 years ago
-
QSB 6.7 aftercooler and heat exchanger O-rings
This topic has 4 replies, has 2 voices, and was last updated by
4 years ago February 9, 2020 at 5:46 am Hello guys! Can somebody tell me diameter of O-rings needed for aftercooler and heat exchanger? Original are expensive,i can get it in Viton but would like to know measurements please,thanks a lot. Regards!
Started by:
in: Cummins Marine Engines
4 RepliesFebruary 9, 2020 at 8:08 am I’m in Australia and order them.. I have 2 sets arriving tomorrow as well as impellers etc.. I just make sure I order a good qty of items to make the postage cost a bit more bearable 😁 The cost of Cummins parts is frightening here.. like I said the 6bta orings are 117aud or 72euro each and I need 4 for a service to both engines.. so it’s definitely worth my trouble… 😁 SteveLast Post by:
posted: 4 years ago
-
Onan genset and 45 error