Forum Topics Started

Viewing 2 topics - 1 through 2 (of 2 total)
    • Cummins Marine Forum Topics
    • Transmission Oil Question

      This topic has 1 reply, has 2 voices, and was last updated byRob Schepis 4 years ago

      November 19, 2019 at 4:18 am Trying to find out if my transmission take regular oil or transmission fluid. Boat is a 2001 Maxum 4100 SCB and the transmissions are ZF Hurth marine. HSW 800 A2 -2.0 Hydraulic Gear driven. THanks

      Started by: jrtracker203 in: Marine Transmissions

      1 Reply
      November 19, 2019 at 4:20 am That is an ATF gear. Haven’t you pulled the dipstick to check level?

      Last Post by: Rob Schepis posted: 4 years ago

    • Occasional Issue Starting Motors

      This topic has 3 replies, has 4 voices, and was last updated byRob Schepis 4 years ago

      June 28, 2019 at 6:59 am I have a 2001 Maxum that is powered with twin 6BAT5.9 – M3 diesels. The problem is that they will not always turn over & start. The symptoms are that you turn the key and sometimes you get nothing. If you keep turning the key off & on they will eventually crank and start. Another example that sometime occurs is that one of them will turnover & start immediately. If I turn it off after about 15 seconds and try starting it a…

      Started by: jrtracker203 in: Cummins Marine Engines

      3 Replies
      July 6, 2019 at 4:24 am In Tony’s first pic the two mag switches to the right are for the grid heaters. Same as the starter mag switches so you can disable the grid system and use those as spares , permanently or for troubleshooting….assuming they are good.

      Last Post by: Rob Schepis posted: 4 years ago

  •  

Viewing 2 topics - 1 through 2 (of 2 total)