Forum Topics Started
Viewing topic 1 (of 1 total)
-
- Cummins Marine Forum Topics
-
-
Pyro/boost install on Yanmar 6ly
This topic has 12 replies, has 4 voices, and was last updated by 5 years ago
June 24, 2018 at 7:05 am I am going to add a pyro/boost monitoring system on my 2006 Yanmar 6ly-stp (370hp) engines. Based on Tony’s advice, I know where to tap into the boost pressure and the pyro probe before the Turbo, however, I’d like the probe to go after the turbo. Is the cap seen on the mixer a possible pyro sensor install point or should I just put in before the turbo and not worry about sensor breaking off and blowing the turbo (if i put it before …
12 RepliesJune 25, 2018 at 1:48 pm Read every article that we’ve created re: exhaust design and then construct a solid plan based on your available options (which includes available physical space)… that’s all you can do. You’ll have to think outside the box… https://www.sbmar.com/category/articles/exhaust-systems/ Re: your arduino… have you figured out how to read the milli-volt signal from the thermocouple? If not, I have a signal amplifier f…
-
Pyro/boost install on Yanmar 6ly
Viewing topic 1 (of 1 total)