QSB 6.7 NMEA 2000- Garmin plotter

[Harry Liquornik]

I have a QSB 6.7 with C Command primier connected to NMEA 2000 network for Garmin plotter. I have it connected to the NMEA 2000 port on wiring harness, not CIB. Engine is showing up on device list on Garmin plotter, however no data is being sent. Is there a setting in the Cummins function menu that needs to be changed or connect network to the CIB.

Topic

[Dave VOgt]

Same question

Hi Harry,

Where on the CIB did you connect NMEA to? The NMEA 2k sensor port?

[Harry Liquornik]

Thanks Brandon
NMEA 2k needs to connected to CIB, when connected to NMEA port on wiring harness engine Was listed but no data, connected to CIB got data
Thanks

[Anonymous]

It should be putting out data through the nmea 2000 network soon as it is connected and and the system is powered up.

Make sure the terminating resistors are installed on both ends of the Nmea network.

Is this a new install or just a new garmin plotter?

Is the ED4 on the CIB showing engine data?

[Author]

Replies