- This topic has 2 replies, 2 voices, and was last updated 10 months ago by .
-
Topic
-
Hi Tony!
Last week, my Port side Cummins QSM11 with Twin disc transmission (MG5082 SC) with manual shifters, started to fail. Even with the lever in NEUTRAL, the shaft is rotating as if it was placed in forward but at a lower speed than if engaged to the FWD position, it also generates a little thrust. (See video attached)
Cable is OK. Oil was replaced 3 months ago. Temp and pressure look good. Reverse works well. Mechanic told me that it is time to service the transmission cause warped clutch plates, worn seal rings, etc. My question is: Will it make more harm to other parts if I run the boat like that for a couple times or for the season before replacing the needed parts?
Tks in advance
Marcelo
Viewing 2 replies - 1 through 2 (of 2 total)
Viewing 2 replies - 1 through 2 (of 2 total)
You must be logged in to reply to this topic.