Need turbo oil feed line fitting help 6CTA

[dnord2]

Recently I replaced both turbos on my 450’s, and I have misplaced this copper fitting in the feed line. One didn’t even have one when I took it off. Im having a tough time finding a replacement, the turbo shop said they fall out and some people don’t even use them. (ie, my port motor turbo side it was missing before I got there). It just seems to be an inverted flare fitting, but I hate putting stuff back together different than I found it. I have been to 2 different hydraulic shops that can’t replicate it.

Is it necessary, will it seal without it? Any thoughts on getting a new one? I’d buy new lines if I had a part number.

Thanks.

Topic

[dnord2]

Thanks you da man! I asked LOTS of people what and where to get that with a lot of blank stares, thanks again. Ordered ✅

[Rob Schepis]

part no. 3924389 “sealing washer”

[Author]

Replies