Cummins Marine Diesel Repower Specialists › Forums › General Discussion › Heat exchanger raw water outlet

  • Creator
    Topic
  • March 8, 2024 at 9:26 am #160647

    Jerry Bradley
    Participant
    Vessel Name: E-Fish-N-Sea
    Engines: 2004 270 6B
    Location: Somers Point NJ
    Country: USA

    Hi all , I’m in the process of redesigning my exhaust system to get it higher above the water line. Is there any way to change the raw water outlet on the heat exchanger? Thanks

  • Creator
    Topic
Viewing 2 replies - 1 through 2 (of 2 total)
  • Author
    Replies
  • April 4, 2024 at 9:48 pm #161758

    Bruce Alker
    Participant
    Vessel Name: Querencia
    Engines: Cummins 6bt5.9-M
    Location: Vintage Marine Channel Islands
    Country: USA

    I would also like to change the raw water outlet of my Sen-Dure heat exchanger on Cummins 6BT to a straight  output instead of the elbow for better clearance around the riser.   Can you recommend a shop that could do the change over from the elbow to a straight outlet?   I think the heat exchanger is a copper-nickel alloy and may be problematic to weld/braze. Thanks.

    March 8, 2024 at 11:59 am #160673

    Rob Schepis
    Forum Moderator
    Vessel Name: Tenacious
    Engines: 6BTA 5.9 330's - "Seaboard Style"
    Location: Long Island, NY
    Country: USA

    Yes sir.

    Cummins Marine Heat Exchanger Modifications

  • Author
    Replies
Viewing 2 replies - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.