- This topic has 4 replies, 3 voices, and was last updated 6 years ago by .
-
Topic
-
I was checking the oil on my 6BT 210 CPL0742 starboard engine and the dipstick snapped at the lower mark.
The full length dipstick is 37″ long (940mm) I tried to put a taper where the dipstick snapped off as it shows the low and full marks but it is getting stuck, im guessing on a lip where the tube enters the block. I checked the part number on the cummins site 3907012 but it does not tell me the length (it shows the same part number for the port engine that has a longer dipstick) Im looking for ideas on how to fix this, should I get the broken part brazed back on?
Cheers Ian
Brisbane, Australia
Viewing 4 replies - 1 through 4 (of 4 total)
Viewing 4 replies - 1 through 4 (of 4 total)
You must be logged in to reply to this topic.