Forum Topics Started

Viewing 2 topics - 1 through 2 (of 2 total)
    • Cummins Marine Forum Topics
    • ZF220A Shift Lever Positions

      This topic has 8 replies, has 3 voices, and was last updated byRobert Buell 3 years ago

      December 14, 2020 at 6:57 am I am planning the installation of two ZF220A transmissions in a counter rotation set up. Can anyone tell me the relationship of the gear selection lever position to output flange rotation? Thanks. Rob

      Started by: Robert Buell in: Marine Transmissions

      8 Replies
      April 12, 2021 at 2:36 pm Just to retire this topic, be advised that rotating the shift shaft clockwise results in enginewise rotation of the transmission output shaft.

      Last Post by: Robert Buell posted: 3 years ago

    • Engine and transmission decision

      This topic has 4 replies, has 3 voices, and was last updated byRobert Buell 3 years ago

      November 8, 2020 at 10:11 am In anticipation of an eventual re-power, I have been a regular follower of this forum for quite some time. Now that the time has come I have some questions that I trust will be answered honestly here. Based on my study here and elsewhere I am firm on the QSB5.9 Recons as my engine choice. I expect either the 330 or 355, the cost as I am being quoted is the same. Seeking your recommendation on that. I am also seeking recommendation on the transmi…

      Started by: Robert Buell in: General Discussion

      4 Replies
      December 14, 2020 at 7:16 am Thank you for your responses to my post, but before they had reached me I had already committed to a decision. Rob

      Last Post by: Robert Buell posted: 3 years ago

  •  

Viewing 2 topics - 1 through 2 (of 2 total)