- This topic has 4 replies, 3 voices, and was last updated 7 years ago by .
-
Topic
-
Haven’t used my generator yet and I’ve been focusing on fixing other things on this new (to me ) boat. Wanted to flush generator with only 60 hours on it and noticed it wasn’t sucking in any raw water. Took out the impeller and replaced it with a new one (old one was fine) and then removed the heat exchanger and find this….see picture. Ā Well, no wonder!
I guess it proves how important it is to not let sea water just sit & destroy.
So my question is should I use something like barnicle buster or just clean by hand and use a 1/8″ rod for the tubes? I bought new end caps, gaskets, etc
Viewing 4 replies - 1 through 4 (of 4 total)
Viewing 4 replies - 1 through 4 (of 4 total)
You must be logged in to reply to this topic.