- This topic has 2 replies, 2 voices, and was last updated 7 years ago by .
-
Topic
-
Hi, I changed my current SmartCraft 5000 (2003 version 1.0) to a NOS 2006, version 3.3. After replacing the display I noticed it offered more information like manifold temp, load, gear temp. My question is this: I didn’t have this information on my old SmartCraft so apparently I don’t have the sensors, can I install /adapt the sensors and wiring to the new SmartCraft display or am I stuck with the information I had on the old display? I’m very mechanical/electrical and do a lot of my own work. Thank You, Tom Ā Mann Bow Tie Ā Ā
Viewing 2 replies - 1 through 2 (of 2 total)
Viewing 2 replies - 1 through 2 (of 2 total)
You must be logged in to reply to this topic.