Cummins Marine Diesel Repower Specialists › Forums › Cummins Marine Engines › Barry Mounts

  • Creator
    Topic
  • January 25, 2020 at 8:34 am #90620

    Dave Carlson
    Participant
    Vessel Name: Bec'n Me
    Engines: 500 QSC
    Location: Fort Myers
    Country: USA

    Looking into a possible engine mount change on QSCs. Is the center stud removable, especially on the new blue mounts sold here or does the engine need to go high enough to clear as is?

    Thanks

  • Creator
    Topic
Viewing 2 replies - 1 through 2 (of 2 total)
  • Author
    Replies
  • January 25, 2020 at 5:09 pm #90673

    Dave Carlson
    Participant
    Vessel Name: Bec'n Me
    Engines: 500 QSC
    Location: Fort Myers
    Country: USA

    Thanks for the reply Tony I didn’t think about possible Loctite.

    January 25, 2020 at 3:34 pm #90666

    Tony Athens
    Moderator
    Vessel Name: Local Banks
    Engines: QSB 6.7 550 HP
    Location: Oxnard, CA
    Country: USA

    The stud is removable on all Barry mounts, but doing so to R&R yours mount is not an easy way to go.. They are very difficult to remove ( tight-tight with Loctite) when new and in a BIG VISE. In a boat all rusted up??

    Post a few good pics of what you are dealing with.

  • Author
    Replies
Viewing 2 replies - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.