Topics Engaged In

Viewing 2 topics - 1 through 2 (of 2 total)
    • Cummins Marine Forum Topics
    • QSM11 Slip Joint leaks

      This topic has 4 replies, has 4 voices, and was last updated byCARL 6 years ago

      November 20, 2017 at 10:52 pm Hi all, Firstly, this subject has been covered extensively online and indeed right here in ‘Tony’s Tips’ so I won’t go into too much detail. My question is a two parted affair regarding the famous exhaust leaks on the QSM. Has anyone tried a graphite gasket instead of the thin metal ones? Is there a reason this is no good? I read somewhere that Seaboard Marine have had some success with a sealant on the slip joint, is thi…

      Started by: Rory McInnes in: Cummins Marine Engines

      4 Replies
      February 22, 2018 at 10:14 am I did not have time, so my attempt has been put off until winter 2018.

      Last Post by: CARL posted: 6 years ago

    • QSM 11 exhaust manifold gasket

      This topic has 4 replies, has 4 voices, and was last updated byTony Athens 6 years ago

      February 19, 2017 at 6:43 pm Tony, replacing the exhaust manifold gaskets on a QSM 11, manifolds re-surfaced I was wondering if you have found a better quality gaskets then the OEM. I’ve been searching around and found a company Remflex which offers QSM gaskets with an internal material to crush to 1/8″ and temperature to 3000 degrees, have you had any experience with this product on any others>? Thanks Tom Ā 

      Started by: Thomas Hug in: Cummins Marine Engines

      4 Replies
      November 13, 2017 at 6:41 am I poster never followed up .. Tony

      Last Post by: Tony Athens posted: 6 years ago

  •  

Viewing 2 topics - 1 through 2 (of 2 total)