- This topic has 4 replies, 2 voices, and was last updated 1 year ago by .
-
Topic
-
Hi, I just removed one rear fitting from one of my 6BTAs Oil pan, and would like to replace these as they are showing quite a bit or rust.
To clarify, this is the 90 degree fitting that threads into the rear of the aluminum oil pan and can be used either for the oil change suction hose or for a crank case vent from the AirSeps (this was eliminated and will use a SBMAR puke bottle system).
Anyways this fitting has a straight thread with oring to the pan and a male flare on the other side that would attach to the hose (oil change suction or Airsep drain).
Can someone help identify the threads on the oring straight portion and the flare type on the other end?
Will post a photo in a minute.
Thank you.
Viewing 4 replies - 1 through 4 (of 4 total)
Viewing 4 replies - 1 through 4 (of 4 total)
You must be logged in to reply to this topic.