Forum Topics Started
-
- Cummins Marine Forum Topics
-
-
Smartcraft Alarms
This topic has 5 replies, has 2 voices, and was last updated by 5 years ago
May 19, 2018 at 2:53 pm Qsl9. Smartcraft version 1. Vessel view display. Gear temp overheat, gear pressure input lo, low seawater flow, fuel level1 input hi, fuel level1 input lo. Gear temp -56. Gear temp 446. All these alarms are present with the key on, engine not running. High gear temp triggers low seawater flow alarm. Will the low seawater flow derate the engine Engine runs fine. Still have fc415. Good oil pressure on mechanical gauge.
5 RepliesJune 27, 2018 at 2:02 pm Smartcraft says everything is OK Might be time for an upgrade.
-
QSL9 fc415
This topic has 13 replies, has 4 voices, and was last updated by 6 years ago
September 9, 2017 at 12:57 pm Qsl9 fault code 415. Low oil pressure. Changed oil and filter. Oil pressure reads 69.6 then drops to 0.0 , alarm triggers again. Last time this happened ECM was replaced as fix after confirming engine had pressure with manual guage. Same numbers as previously. Is there a reset in smart craft menu that will clear oil pressure so it will read correctly? Factory reset? Thank you
13 RepliesOctober 24, 2017 at 4:28 pm Replaced air intake manifold sensor (boost pressure). No change. One other qsl9 in Maine with same fault code was fixed by replacing it so figured it was worth trying.
-
Smartcraft Alarms