Forum Topics Started

Viewing 2 topics - 1 through 2 (of 2 total)
    • Cummins Marine Forum Topics
    • disappearing posts

      This topic has 5 replies, has 3 voices, and was last updated byCorey Schmidt 6 years ago

      September 8, 2017 at 1:52 pm Three times today I replied to a thread I started and the post disappears after I edited it. any ideas?

      Started by: egstasea in: General Discussion

      5 Replies
      November 1, 2017 at 7:35 am I do not see you posts at all… usually if the system “flags” the post as spam, then I will see it and review it before allowing it to post to the site… Try to post again?

      Last Post by: Corey Schmidt posted: 6 years ago

    • 6CTA intermittent rpm issue

      This topic has 14 replies, has 4 voices, and was last updated byegstasea 6 years ago

      September 5, 2017 at 12:22 pm I have a 2002 Tiara 40 Express. The boat is wide and heavy by design. I normally I have 1/2 fuel, 1/2 water, and 2 people, no dinghy or extra transom weight. It has (2) 6CTA-M3 CPL 8089. I have recently developed an issue where the port engine does not spool up like the starboard, always on the first attempt of the day. The boost gauge for port stays on zero, while the starboard is building normally. The boat takes a hard left, so I don…

      Started by: egstasea in: Cummins Marine Engines

      14 Replies
      September 10, 2017 at 3:35 pm The problem was the glendening synchronizer. I don’t use the synchronizor to bring it on to plane. The port is the slave motor and the throttle cable was not engaged at the glendenning. The black smoke must have been the the starboard over loaded. I have underwater exhaust, so it is difficult to see which engine is smoking.

      Last Post by: egstasea posted: 6 years ago

  •  

Viewing 2 topics - 1 through 2 (of 2 total)