Forum Replies Created
-
AuthorReplies
-
April 15, 2021 at 1:05 pm #113501
daleParticipanti read your other post and you state the 28si do not like the diode type of isolator. would using the sense wire fix this? what isolator would you use? also i see the 28si is available in the long or j180 hinge. the long hinge is about .60″ longer than the short. will both fit?
thanks again
dale cote
dreammaker charters
cabo san lucas mex.August 1, 2017 at 4:59 pm #21428
daleParticipanti bought the original engine used from you about 8 years a cpl 1928. the new long block is a cpl 1975 remanufactured by Cummins ReCon, i am in mexico and do not know if the sell these in the us. but they come with valve cover to oil pan front cover to rear seal for about $7500.00. i think it’s a great deal.
so my question is does a crankshaft with wear sleeve use the same seal part# as a stock crank? what would be the part#
also an a different subject i just installed a set of your sea water pumps on my other boat, the impellers seem a lot
softer than the sherwood, at 600 hours the sherwood were gone and i usualy changed them at 500hrs, what is your estimated hours in your impellers
thanks daleApril 1, 2017 at 10:12 am #16970
daleParticipantsorry i don’t see, start new topic
-
AuthorReplies