Forum Topics Started

Viewing 3 topics - 1 through 3 (of 3 total)
    • Cummins Marine Forum Topics
    • Load at Idle in Neutral?

      This topic has 5 replies, has 2 voices, and was last updated byQSCIsMe 5 years ago

      August 21, 2018 at 6:58 am 2004 QSC540s with the Diesel View displays showing 24% load on the port engine and 19% load on the starboard at idle in neutral. Also noticed fuel burn was worse than usual. What could be causing such a load in neutral at idle?

      Started by: QSCIsMe in: Cummins Marine Engines


      5 Replies
      August 22, 2018 at 6:26 am Also I’m not sure about the prop shafts spinning. Didn’t check for that when I was on the boat. If they were spinning it would have been very slowly since I was anchored with the engines on all day (didn’t want to risk a battery failure before I have that figured out) and would have noticed if they were spinning enough to move the boat.

      Last Post by: QSCIsMe posted: 5 years ago

    • Cap with >15psi?

      This topic has 4 replies, has 2 voices, and was last updated byQSCIsMe 7 years ago

      April 8, 2017 at 11:46 pm Possibly losing some coolant on stbd engine, QSC 540. Ā Some residue around the cap. Ā One suggestion has been to increase the psi of the cap from the 15 psi to 17-18 psi. Ā Would that increase the risk of other problems? Cap on there now is new.

      Started by: QSCIsMe in: Cummins Marine Engines


      4 Replies
      April 9, 2017 at 7:38 pm Ok next time on the boat I’ll take pics. Ā The problem is stbd engine every now and then loses coolant. Ā Some trips not an ounce is lost, and other trips close to a quart. Ā No correlation with running the engines hard or not. Ā Both caps are new but I can try switching.

      Last Post by: QSCIsMe posted: 7 years ago

Viewing 3 topics - 1 through 3 (of 3 total)