Cummins Marine Diesel Repower Specialists › Forums › General Discussion › Micro Commadner 585CE

  • Creator
    Topic
  • July 9, 2018 at 5:34 am #34508

    Rick Bucovaz
    Participant
    Engines: 83 6CTA

    Hello, I am in search for 3 inch nylon belts for Mathers 585ce actuator. Any ideas where I can locate them?

  • Creator
    Topic
Viewing 3 replies - 1 through 3 (of 3 total)
  • Author
    Replies
  • March 11, 2021 at 12:46 am #111552

    mauri pane
    Participant
    Vessel Name: no limits
    Engines: caterpillar
    Location: francia
    Country: monaco

    hello i need the drive belts too.
    Have you found them?
    where is it ?
    thank you
    good wind

    July 9, 2018 at 8:58 am #34519

    Rick Bucovaz
    Participant
    Engines: 83 6CTA

    Yeah, not much mention about the belts and no part numbers as far as I can tell. I may have to make my own or go “Mechanical” Thanks Tony!

    July 9, 2018 at 7:13 am #34512

    Tony Athens
    Moderator
    Vessel Name: Local Banks
    Engines: QSB 6.7 550 HP
    Location: Oxnard, CA
    Country: USA

    Mathers 580CE parts support

    Did a quick seach on GOOGLE– Not impressed with on-line support for the earlier 580 controls…. Think you’ll be special ordering them thru your closest ZF Dealer?………………………………………..If I had a part number, I’m sure I could get them direct from ZF..

    Tony

  • Author
    Replies
Viewing 3 replies - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.